Lighting Submenu - Mercedes-Benz Sprinter Operating Instructions Manual

On-board computer (vehicles with steering wheel buttons)
X
Press the 9 button to select the
function.
The selection marker is on the current setting.
X
Press the W or X button to select the
12 h or 24 h
clock format.
Screen illumination submenu
Activating/deactivating Highbeam Assist
Using the steering wheel buttons
X
Press the V or U button repeatedly
Settings
until the menu appears in the dis-
play.
X
Press the 9 button to switch to the sub-
menu selection.
X
Press the W or X button to select the
Lighting
submenu.
X
Press the 9 button to select the
beam Assist
function.
The selection marker is on the current setting.
X
Press the W or X button to switch
On or Off
Highbeam Assist
i For safety reasons, it is not possible to reset
Highbeam Assist
the
settings during a journey. You will see the fol-
lowing message in the display:
only possible at
For further information about Highbeam Assist,
Y
see ( page 92).
Switching the daytime driving lights
on/off
If you switch the daytime driving lights function
to On, the daytime driving lights will automati-
cally light up when the engine is running.
12/24 h
High‐
.
function to the factory
Setting
standstill.
For safety reasons, it is only possible to change
this setting when the vehicle is stationary. The
On
factory setting is in countries in which con-
stant headlamp mode or daytime driving lights
are mandatory.
Using the steering wheel buttons
X
Press the V or U button repeatedly
Settings
until the menu appears in the dis-
play.
X
Press the 9 button to switch to the sub-
menu selection.
X
Press the W or X button to select the
Lighting submenu.
X
Press the 9 button to select the
driv. lights
function.
The selection marker is on the current setting.
X
Press the W or X button to switch the
daytime driving lights On or Off.
i If you turn the light switch to T or L,
the corresponding lamp switches on. If you
turn the light switch to Ã, the daytime
driving lights remain switched on.
i For safety reasons, it is not possible to reset
Daytime driv. lights
the
factory setting while the vehicle is in motion.
You will see the following message in the dis-
Setting only possible at stand‐
play:
still.
Switching surround lighting on or off
Using the steering wheel buttons
X
Press the V or U button repeatedly
Settings
until the menu appears in the dis-
play.
X
Press the 9 button to switch to the sub-
menu selection.
X
Press the W or X button to select the
Lighting
submenu.
X
Press the 9 button to select the
lighting
function.
The selection marker is on the current setting.
X
Press the W or X button to switch the
On or Off
surround lighting
191
Daytime
function to the
Loc.
.
Z