Identification Plates; Service Products And Capacities - Mercedes-Benz Sprinter Operating Instructions Manual

The transmission output of the mobile phone or
two-way radio may not exceed the following
maximum transmission output (PEAK):
Frequency range
Shortwave
(f < 50 MHz)
4 m waveband
2 m waveband
Channel group com-
munication/Tetra
70 cm waveband
GSM/UMTS/LTE

Identification plates

Vehicle identification plate with vehi-
cle identification number (VIN)
Example: vehicle identification plate on the base of
the driver's seat
Depending on the type of vehicle, vehicle iden-
tification plate : is located on the base of the
driver's seat or in the engine compartment.
X
Open the driver's door or bonnet
Y
( page 242).
You will see vehicle identification plate :
with the vehicle identification number (VIN)
and the permissible weight data.
Vehicle identification plate : may also con-
tain the following data:
payload
R
kerb weight
R
number of passenger seats
R
Maximum trans-
mission output
(PEAK)
100 W
30 W
50 W
35 W
35 W
10 W

Service products and capacities

i The data is vehicle-specific and can differ
from that shown. Always observe the specifi-
cations on your vehicle's identification plate.
Engine number
The engine number is stamped on the crank-
case. More information may be obtained at any
qualified specialist workshop.
Service products and capacities
Important safety notes
G
WARNING
Service product can be poisonous and haz-
ardous to health. There is a risk of injury.
Observe the instructions on the respective
original container when using, storing and dis-
posing off service products. Always store ser-
vice products in the sealed original container.
Always keep service products out of the reach
of children.
H
Environmental note
Dispose of service products in an environ-
mentally-responsible manner.
Service products include the following:
fuels, e.g. petrol, diesel
R
lubricants, e.g. engine oil, transmission oil
R
coolant
R
brake fluid
R
washer fluid
R
climate control system refrigerants
R
Approved service products comply with the
highest quality standards and are listed in the
Mercedes-Benz Specifications for Service Prod-
ucts. Only use service products approved for the
vehicle. This is an important condition for the
implied warranty.
You will recognise the service products
approved by Mercedes-Benz by the inscription
on the container:
MB-Freigabe (e.g. MB-Freigabe 228.5)
R
MB Approval (e.g. MB Approval 228.5)
R
Other identifications and recommendations
refer to a quality level or a specification accord-
295
Z