Reversing Camera - Mercedes-Benz Sprinter Operating Instructions Manual

Care
260
Mercedes-Benz car shampoo or cleaning
cloths.
Cleaning the sensors
! Do not use dry, coarse or hard cloths and do
not scrub. You will otherwise scratch or dam-
age the sensors.
If you clean the sensors with a high-pressure
cleaner or steam cleaner, observe the infor-
mation provided by the manufacturer regard-
ing the distance to be maintained between
the vehicle and the nozzle of the high-pres-
sure cleaner.
PARKTRONIC sensors (example: front bumper, left
side of vehicle)
X
Clean all sensors : in the front and rear
bumpers with water, shampoo and a soft
cloth.
Cleaning the reversing camera
! Do not use dry, coarse or hard cloths and do
not scrub. You could otherwise scratch or
damage the lens of the reversing camera.
When cleaning the vehicle with a high-pres-
sure or steam cleaner, observe a minimum
distance of 50 cm to the reversing camera. Do
not aim directly at the reversing camera. You
could otherwise damage the reversing cam-
era.
Reversing camera in the middle of the roof above
the third brake lamp
Camera lens
:
X
Clean camera lens : with clean water and a
soft cloth.
Make sure that you do not apply any wax to
camera lens : when waxing the vehicle. If nec-
essary, remove the wax using water, shampoo
and a soft cloth.
Cleaning the sliding door
X
Remove foreign objects from the vicinity of
the contact surfaces and contact pins of the
sliding door.
X
Clean the contact surfaces and contact pins
with a mild cleaning agent and a soft cloth.
Do not oil or grease the contact plates and con-
tact pins.
Steps
Cleaning the electrical step
Clean the electrical step at least once a month.
Make sure that no dirt accumulates in the hous-
ing or on the step.
X
Extend the electrically operated step
Y
( page 71).
X
Close the sliding door until the door lock
engages.
The electrical step remains extended for
cleaning.
X
Clean the electrical step and the housing with
a high-pressure cleaner.
X
After cleaning, spray the step guides on each
side with silicone spray when the housing and
electrical step are dry.
Do not use oil or grease as a lubricant.
X
Retract the electrical step.