Identification Plates - Mercedes-Benz SLC 2018 Operator's Manual

ing. Be sure to observe the manufacturer's Sup-
plement when installing.
Deviations with respect to frequency bands,
maximum transmission outputs or antenna
positions must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the fol-
lowing values:
Frequency band
Short wave
3 - 54 MHz
4 m waveband
74 - 88 MHz
2 m waveband
144 - 174 MHz
Trunked radio system/
Tetra
380 - 460 MHz
70 cm waveband
400 - 460 MHz
Mobile communications
(2G/3G/4G)
The following can be used in the vehicle without
restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
RF transmitters with transmitter frequencies
R
in the 380 - 410 MHz waveband and a maxi-
mum transmission output of up to 2 W
(trunked radio/Tetra)
Mobile phones (2G/3G/4G)
R
There are no restrictions when positioning the
antenna on the outside of the vehicle for the
following wavebands:
Trunked radio system/Tetra
R
70 cm waveband
R
2G/3G/4G
R

Identification plates

Vehicle identification plate with vehi-
cle identification number (VIN)
Maximum
transmission
output
100 W
30 W
X
50 W
10 W
35 W
10 W
Example: vehicle identification plate (USA only)
:
;
Example: vehicle identification plate (Canada only)
:
;
i
Identification plates
Open the driver's door.
You will see vehicle identification plate :.
VIN
Vehicle model
VIN
Paint code
The data shown on the vehicle identification
plate is used only as an example. This data is
different for every vehicle and can deviate
289
Z