Alternate Parts; Options; Location Requirements - Whirlpool CHW9050 Service Manual

ALTERNATE PARTS

To purchase any of the items listed here, call
the toll-free number in the "Assistance or
Service" section.
If there is a (an) Purchase item
Overhead sewer Sump pump system (If not
already available)
Floor drain Siphon break, Part
Number 285834;
Additional drain hose,
Part Number 8318155;
and Connector kit, Part
Number 285835
Drain hose too 4 ft. (1.2 m) drain hose
short extension kit, Part Number
285863
Water faucet 2 longer water fill hoses:
beyond reach of 6 ft (1.8 m) Part Number
fill hoses 76314, 10 ft (3.0 m) Part
Number 350008
(not for 50z)

OPTIONS

Pedestal
An optional pedestal is available for this
washer. The pedestal will add to the total
height of the washer.
Pedestal Pedestal
w/o legs
4" 2 7/8"
10" 8 7/8"
Package 2 7/8"
of ten 4"
Color Model
number
White WHP0400VW
White WHP1000VW
White WHP0401VW

LOCATION REQUIREMENTS

Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Selecting the proper location for the washer
improves performance and minimizes noise
and possible washer "walk."
This washer can be installed under a custom
counter, or in a basement, laundry room,
closet, or recessed area. See "Drain System."
Companion appliance location requirements
should also be considered. Proper installation
is the responsibility of the installer / owner.
What is needed
• A water heater set to deliver 120°F (49°C)
water to the washer.
• A grounded electrical outlet located within
5 ft (1.524 m) of where the power cord is
attached to the back of the washer. See
"Electrical Requirements."
• Hot and cold water faucets located less
than 4 ft (1.2 m) of the hot and cold water
fill valves, and water pressure of 20-100 psi
(137.9-689.6 kPa).
• A level floor with a maximum slope of 1"
(2.5 cm) under entire washer. Installing
the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is
not recommended.
2-2