Installation Clearances - Whirlpool CHW9050 Service Manual

• A sturdy and solid floor to support the
Location Requirements
washer with a total weight (water and load)
of 400 lbs (180 kg).
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
Do not operate the washer in temperatures
basement, laundry room, closet, or recessed area. See "Drain
below 32°F (0°C). Some water can remain
System." Companion appliance location requirements should
also be considered. Proper installation is your responsibility.
in the washer and can cause damage in low
You will need
temperatures.
A water heater set to deliver 120°F (49°C) water to the
■
washer.

Installation clearances

A grounded electrical outlet located within 6 ft (1.8 m)
■
of where the power cord is attached to the back of the
washer. See "Electrical Requirements."
• The location must be large enough to allow
Hot and cold water faucets located within 4 ft (1.2 m) of
■
the hot and cold water fill valves, and water pressure of
the washer door to be fully opened.
20-100 psi (137.9-689.6 kPa).
A level floor with a maximum slope of 1" (25 mm) under
■
• Additional spacing should be considered for
entire washer. Installing the washer on soft floor surfaces,
ease of installation and service.
such as carpets or surfaces with foam backing, is not
recommended.
A sturdy and solid floor to support the washer with a total
■
• Additional clearances might be required for
weight (water and load) of 400 lbs (180 kg).
wall, door, and floor moldings.
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage
in low temperatures.
• Additional spacing of 1" (2.5 cm) on all sides
Installation clearances
of the washer is recommended to reduce
noise transfer. The location must be large enough to allow the washer
■
door to be fully opened.
Additional spacing should be considered for ease of
■
• Companion appliance spacing should also
installation and servicing. The door opens more than 90°,
be considered.
and it is not reversible.
Additional clearances might be required for wall, door, and
■
floor moldings.
Additional spacing of 1" (25 mm) on all sides of the washer
■
is recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
■
Washer dimensions:
Washer Dimensions
1
50 / "
2
(1282 mm)
Door is not reversible.
27"
(686 mm)
5
44
/
8
(1134 mm)
13
37 / "
16
(961 mm)
13
28 / "
16
(732 mm)
A floor drain should be provided under a
bulkhead. Prefabricated bulkheads with
electrical outlets, water inlet lines, and drain
facilities should be used only where local
codes permit.
"
2-3