Vertical 14 Coin Slide Operation And Vend Price Change - Whirlpool CHW9050 Service Manual

VERTICAL 14 COIN SLIDE OPERATION
1. The middle six coin slots in this coin slide
are wide enough to accept two coins
together in each slot. This allows a total
possible vend price of $3.50 per slide push.
2. On electronic control washers, the coin slide
has an extension with a switch to signal the
control board that the proper vend price has
been deposited.
3. When the coin slide is activated, it will push
a lever. The lever pivots and presses the
arm of the switch. It is important to make
sure the switch is activated for proper
operation of the washer.
4. If the switch does not activate, the end of
the lever can be bent to press the switch
arm further. There is a very slight audible
click when the switch is activated.
Pivoting
Lever
Lever End
AND VEND PRICE CHANGE
Switch Arm
5. The coin slide upper switch plate has
two tabs that keep the pivoting lever from
pivoting too far in either direction. If the
lever pivots too far, the coin slide can miss
catching the lever, one way or the other, and
the lever will not be correctly reset.
Lever Tab
6. To remove the coin slide extension,
disconnect the springs from the hooks.
Coin slides may have one or two springs,
depending on the manufacturer.
7. Remove the two Phillips screws located
below the springs.
8. Remove the cover with springs attached
from the top of the coin slide extension.
4-46
Lever Tab
Phillips
Screws
Springs
Spring
Hooks