Basic Operation; Set Up Instructions - Whirlpool CHW9050 Service Manual

BaSiC OPeraTiOn

COMMerCiaL FrOnT LOaDinG WaSHer
This washer can hold up to an 18 lb (8.2 kg)
load of laundry.
This washer can hold up to an 18 lb (8.2 kg)
1. Insert coins until "SELECT CYCLE" flashes
load of laundry.
in display.
1. Insert coins until "SELECT CYCLE" flashes
2. When a debit card is required rather than
in display.
coins, in Enhanced Debit mode, the card
balance will display when a debit card is
2. When a debit card is required rather than
inserted into the reader. When set for free
coins, in Enhanced Debit mode, the card
vend, "SELECT CYCLE" will be displayed.
balance will display when a debit card is
inserted into the reader. When set for free
3. Door must be closed before cycle selection
vend, "SELECT CYCLE" will be displayed.
is made.
3. Door must be closed before cycle selection
4. Door locks at the beginning of a cycle and
is made.
remains locked for the entire cycle.
4. Door locks at the beginning of a cycle and
5. Press fabric setting button for the wash
remains locked for the entire cycle.
cycle desired. Then select wash water
temperature, if desired. If a temperature
is not selected a default temperature is set
5. Press fabric setting button for the wash
automatically. After the cycle is started, the
cycle desired. Then select wash water
time will display and count down.
temperature desired. If a temperature is not
selected a default temperature is set
automatically. After the cycle is started, the
6. When a cycle is interrupted, by disruption
of power, "RESELECT CYCLE" will flash in
time will display and count down.
the display. To restart the washer, reselect
desired cycle.
6. When a cycle is interrupted, "RESELECT
CYCLE" will flash in the display. To restart
the washer, press any button.
BASIC OPERATION

SET UP INSTRUCTIONS

SeT uP inSTruCTiOnS
3-1
3-1
OF "W" Serie
DEBIT CARD READY: This washer is debit
card 'cable' ready. It will accept a variety of
debit systems, but does not come with a debit
DEBIT CARD READY: This appliance is debit
card reader. Refer to the debit card reader
card "cable" ready. It will accept a variety of
manufacturer for proper washer setup. In
debit card systems, but does not come with
models converted to a Generation 1 debit
a debit card reader. Refer to the debit card
card system, a debit pulse represents the
reader manufacturer for proper washer setup.
equivalent of 1 coin.
In models converted to a Generation 1 debit
card system, a debit pulse represents the
NOTE: Adding a card reader requires a 60"
equivalent of 1 coin.
communication Cable to connect UIC to Card
Reader mounted in a metercase. Request this
DISPLAY: After the washer has been installed
cable from the Card Reader supplier.
and plugged in, the display may show:
"0 MINUTES" " . Once the washer has been
DISPLAY: After the washer has been installed
plugged in and the washer door opened and
and plugged in, the display may show
closed, the display will show the price. In
"0 MINUTES". Once the washer has been
washers set for free cycles, the display will
plugged in and the washer door opened and
flash "SELECT CYCLE". Otherwise the cycle
closed, the display will show the amount
price will be displayed in dollars and cents.
required to start the cycle. In washers set for
free cycles, the display will flash "SELECT
CYCLE". Otherwise the cycle price will be
displayed in dollars and cents unless Price
Suppression is chosen in the owner settings.
S