Whirlpool CHW9050 Service Manual page 109

PROBLEM
Washer vibrates
Incorrect water temperature
1. Remove shipping system.
2. Check installation.
3. Check leveling feet.
• Make sure all legs are locked to the base of the washer, and that all feet are
firmly in contact with the floor.
1. Check that the inlet hoses are connected properly at the back of the washer and
make sure the hoses are connected properly to the dispenser inlet ports.
2. Unplug washer or disconnect power.
3. Check water temperature sensor for an abnormal condition. See the Water
Temperature Sensor section, (See page 5-7).
4. Plug in washer or reconnect power.
5. Verify washer operation by running a Diagnostic Test or any cycle.
6-19
POSSIBLE CAUSE / TEST