Table of Contents
Advertisement
Available languages
Available languages
It is recommended that fiberglass items not be washed in
coin-operated washers. If these items are washed in the washer,
run the washer through a complete cycle to rinse any residue
away that might be left in the washer.
Transporting Your Washer
• Shut off both water faucets. Disconnect and drain water inlet
hoses.
• Disconnect drain hose from drain system and drain any
remaining water into a pan or bucket. Disconnect drain hose
from back of washer.
• Unplug power cord.
• Place inlet hoses and drain hose inside washer basket.
• Drape power cord over edge and into washer basket.
• Place packing tray from original shipping materials back inside
washer and reuse shipping base to support the motor and tub.
If you do not have original packaging, place heavy blankets
or towels above basket, between the washer top and the tub
ring. Close lid and place tape over lid and down the front of the
washer. Keep lid taped until washer is moved to new location.
IF YOU NEED ASSISTANCE
Contact your authorized Commercial Laundry distributor. To
locate your authorized Commercial Laundry distributor, or for
web inquiries, visit www.WhirlpoolCommercialLaundry.com.
If you cannot locate your distributor, the Commercial Laundry
Support Center will answer any questions about operating
or maintaining your washer not covered in the Installation
Instructions.
Just dial 1-800-807-6777 — the call is toll-free.
When you call, you will need the washer model number and serial
number. Both numbers can be found on the serial-rating plate
located on the washer.
ALTERNATE PARTS &
ACCESSORIES
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number in the "If You Need Assistance" section.
If You Have:
Overhead sewer
1" (25 mm) standpipe
Floor drain system
Drain beyond reach
of drain hose
Water faucets beyond
reach of fill hoses
Accessories
Whirlpool Corporation, Benton Harbor, Michigan 49022, U.S.A.
You Will Need:
Standard 20 gallon (76 L)
39" (990 mm) tall drain tub or
utility sink, sump pump and
connectors (available from local
plumbing suppliers)
2" (51 mm) diameter to
1" (25 mm) diameter Standpipe
Adapter, Part Number 3363920.
Connector Kit, Part Number
285835
Siphon break, Part Number
285320. Connector Kit (x2), Part
Number 285835. Extension Drain
Hose, Part Number 285863
4 ft (1.2 m) Drain Hose Extension,
Part Number DRNEXT4
2 longer water fill hoses:
6 ft (1.8 m) 90° bend hose,
Part Number 76314, 10 ft (3.0 m)
Part Number 8212656RP
Inlet hoses are sold as a pair
in kit 8212545RP
Washer Drip Trays,
Part Number 8212526
Fabric Softener Dispenser Kit,
Part Number 63594
11
Advertisement
Table of Contents
