General User Information - Whirlpool CHW9050 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere.
ESD may damage or weaken the
electronic control assembly. The new
control assembly may appear to work
well after repair is finished, but failure
may occur at a later date due to ESD
stress.
n Use an anti-static wrist strap. Connect
wrist strap to green ground connection
point or unpainted metal in the
appliance.
-OR-
Touch your finger repeatedly to a green
ground connection point or unpainted
metal in the appliance.
n Before removing the part from its
package, touch the antistatic bag to
a green ground connection point or
unpainted metal in the appliance.
n Avoid touching electronic parts or
terminal contacts; handle electronic
control assembly by edges only.
n When repackaging failed electronic
control assembly in antistatic bag,
observe above instructions.
GENERAL USER
INFORMATION
SCROLLING 'OUT OF ORDER' SHOWING IN
DISPLAY, FOLLOWED BY A FAILURE CODE
This condition indicates the washer is
inoperative.
'0 MINUTES' SHOWING IN DISPLAY
This indicates the cycle is complete and the
washer cannot be operated. Coins dropped
or debit inputs during this condition will be
stored in escrow but cannot be used until
normal operation is restored by opening and
closing the door. If a door switch fails, it must
be replaced before normal operation can be
restored.
COLD START (Initial first use)
Washer is programmed at the factory as
follows:
n 11 minute wash period
n 3 rinses (extra rinse not enabled)
n $2.00 wash price (9050 model)
n $0 wash price (9060 model)
WARM START (after power failure)
A few seconds after power is restored, if a
cycle was in progress at the time of the power
failure, 'RESELECT CYCLE' will flash in the
display, indicating the need for a button press
to restart washer.
3-2