Door Lock / Latch Assembly - Whirlpool CHW9050 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Open the washer door.
4. Remove two T-20 screws that secure the
door lock assembly to the front panel of the
washer.
Two T-20
Screws

DOOR LOCk / LATCH ASSEMBLY

5. To remove the spring loaded outer retainer
wire for the bellow, use a small flat blade
screwdriver to expand the spring with the
loops at each end of the spring.
6. Pull the retainer out of the groove around
the bellow.
7. Push the right side of the bellow into the
cabinet opening.
Bellow
8. Reach in behind the front panel and pull the
door lock assembly out.
4-16
Retaining Wire
Tension Spring