Power Supply Cord - Whirlpool CHW9050 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Open the washer top (See page 4-3).
4. Remove the screw from the green ground
wire. (See first picture in next column)
5. Pull the connectors with white and black
wires from the RFI line filter terminals.
RFI Line
6. Pull the washer away from the wall far
enough to access the power supply cord on
the back panel.

POWER SUPPLY CORD

Filter
Ground Wire Screw
7. Remove the one 1/4" hex head screw
securing the power supply cord strain relief
to the back panel of the washer.
1/4" Hex
Head Screw
8. Push the wire connectors out the back panel
of the washer.
4-13
2 Wire
Connectors