Front Panel - Whirlpool CHW9050 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the door lock assembly.
(See page 4-16).
4. Remove the control panel cover.
(See page 4-2).
5. Remove the lower service panel
(See page 4-21).
6. Remove two 1/4" hex head screws, that
were hidden by the lower service panel, that
secure the bottom of the front panel to the
washer side panels.
Two 1/4" Hex Head Screws

FRONT PANEL

7. Remove two 1/4" hex head screws, that
were hidden by the control panel cover,
that secure the top of the front panel to the
washer side panels.
Top left front corner
n If not removed earlier, the door lock
assembly is attached to the inside of the
front panel. Disconnect the wire connectors
to the door lock assembly to be able to
remove the front panel completely.
4-36
Top right front corner
Two 1/4"
Hex Head
Screws