Whirlpool CHW9050 Service Manual page 49

7. Lift the clip that holds the wires to the pump
and slide the wires down to release them
from the clip.
8. Open the lid that covers the wire connector
to the pump. Pull the wire connector off to
disconnect it from the pump.
Cover
9. Use a flat blade screwdriver to lift the right
edge of the rubber pad, on the right support,
out of the hole in the washer base.
10. Slide the pump to the right and then lift it
from the base of the washer.
Tab
Wire Connector
Wire Clip
Rubber Pad
NOTE: The 2 screws that secure the rubber
mounting piece to the bottom of the pump
support do not need to be removed to
remove the pump assembly.
NOTE: The filter has a large keyed shape,
molded into the top, which fits into a
corresponding shape in the filter housing
to avoid improper filter orientation when
reinstalled.
4-23