Voice Mail Parameters - AudioCodes Mediant 2000 User Manual

User's Manual
Parameter
Web: Max Digits in Phone Num
EMS: Max Digits in Phone
Number
[MaxDigits]
Web: Inter Digit Timeout for
Overlap Dialing [sec]
EMS: Interdigit Timeout (Sec)
[TimeBetweenDigits]

45.11.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail
Interface
[VoiceMailInterface]
Version 6.6
only when ISDN overlap dialing is used (ISDNRxOverlap is set
to 1).

If the DialPlanIndex parameter is configured (to select a Dial
Plan index), then the device first attempts to locate a matching
digit pattern in the Dial Plan file, and if not found, then attempts
to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

For more information on digit mapping, see 'Digit Mapping' on
page 330.
Defines the maximum number of collected destination number
digits that can be received from the Tel side when Tel-to-IP ISDN
overlap dialing is performed. When the number of collected digits
reaches this maximum, the device uses these digits for the called
destination number.
The valid range is 1 to 49. The default is 30.
Note: Instead of using this parameter, Digit Mapping rules can be
configured.
Defines the time (in seconds) that the device waits between digits
that are received from the PSTN or IP during overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Voice Mail Parameters
Enables the device's Voice Mail application and determines the
communication method used between the PBX and the device.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)

[7] IP2IP = The device's IP-to-IP application is used for
interworking between an IP Voice Mail server and the device. This
is implemented for sending unsolicited SIP NOTIFY messages
received from the Voice Mail server to an IP Group (configured
using the NotificationIPGroupID parameter).

[8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4, section
9.5.1.1. Enables MWI interworking from IP to Tel, typically used for
BRI phones.
603
45. Configuration Parameters Reference
Description
Description
Mediant 2000