AudioCodes Mediant 2000 User Manual page 609

User's Manual
Parameter
Web/EMS: Use Destination
As Connected Number
[UseDestinationAsConne
ctedNumber]
Web: Caller ID Transport
Type
EMS: Transport Type
[CallerIDTransportType]
Reject Anonymous Calls Per Port Table
[RejectAnonymousCallP
erPort]
Version 6.6
number and name in the Q.931 Connect message, including its
privacy.
Enables the device to include the Called Party Number, from outgoing
Tel calls (after number manipulation), in the SIP P-Asserted-Identity
header. The device includes the SIP P-Asserted-Identity header in 180
Ringing and 200 OK responses for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
Notes:

If the received Q.931 Connect message contains a Connected
Party Number, this number is used in the P-Asserted-Identity
header in 200 OK response.

For this feature, you must also enable the device to include the P-
Asserted-Identity header in 180/200 OK responses, by setting the
parameter AssertedIDMode to Add P-Asserted-Identity.

This parameter is applicable to ISDN, CAS interfaces.
Determines the device's behavior for Caller ID detection.

[0] Disable = The caller ID signal is not detected - DTMF digits
remain in the voice stream.

[1] Relay = (Currently not applicable.)

[3] Mute = (Default) The caller ID signal is detected from the PSTN
side and then erased from the voice stream.
This table parameter determines whether the device rejects incoming
anonymous calls. If enabled, when a device's FXS interface receives
an anonymous call, it rejects the call and responds with a SIP 433
(Anonymity Disallowed) response.
The format of this parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable;
[\RejectAnonymousCallPerPort]
Where,

Enable = accept [0] (default) or reject [1] incoming anonymous
calls.
For example:
RejectAnonymousCallPerPort 0 = 0;
RejectAnonymousCallPerPort 1 = 1;
Note: This parameter is applicable only to FXS interfaces.
609
45. Configuration Parameters Reference
Description
Mediant 2000