Channel Parameters; Voice Parameters - AudioCodes Mediant 2000 User Manual

User's Manual
Parameter

45.10 Channel Parameters

This subsection describes the device's channel parameters.

45.10.1 Voice Parameters

The voice parameters are described in the table below.
Parameter
Web/EMS: Input Gain
[InputGain]
Web: Voice Volume
EMS: Volume (dB)
[VoiceVolume]
Version 6.6
TelProfile_TimeForReor Time For Reorder Tone
derTone
TelProfile_EnableDIDW Enable DID Wink
ink
TelProfile_IsTwoStage Dialing Mode
Dial
TelProfile_DisconnectO Disconnect Call on
nBusyTone Detection of Busy Tone
TelProfile_EnableVoice Enable Voice Mail
MailDelay Delay
TelProfile_DialPlanInde Dial Plan Index
x
TelProfile_Enable911P Enable 911 PSAP
SAP
TelProfile_SwapTelToIp Swap Tel To IP Phone
PhoneNumbers Numbers
TelProfile_EnableAGC Enable AGC
TelProfile_ECNlpMode EC NLP Mode
TelProfile_DigitalCutThr -
ough
TelProfile_EnableFXOD -
oubleAnswer
TelProfile_CallPriorityM -
ode
Voice Parameters
Defines the pulse-code modulation (PCM) input gain control (in
decibels). This parameter sets the level for the received (PSTN-
to-IP) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
Defines the voice gain control (in decibels). This parameter sets
the level for the transmitted (IP-to-PSTN) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
583
45. Configuration Parameters Reference
Description
TimeForReorderTone
EnableDIDWink
IsTwoStageDial
DisconnectOnBusyTone
-
DialPlanIndex
Enable911PSAP
SwapTEl2IPCalled&CallingNumb
ers
EnableAGC
ECNLPMode
DigitalCutThrough
EnableFXODoubleAnswer
CallPriorityMode
Description
Mediant 2000