Configuring Multicast; Using P2P To Connect To The Honview Touch App - Honeywell HRHT4041 Remote User Manual

58 | Performance Series HQA Digital Video Recorder Remote User Guide

Configuring Multicast

Multicast is a transmission mode for data packets. When there are multiple hosts to receive the
same data packets, multiple cast is the best option for reducing the bandwidth and the CPU
load. The source host can send out just one data for transit. This function also depends on the
relationship of the group member and the router group.
Click Multicast in the Network configuration interface to open the Multicast configuration
interface.
1.
2.
3.

Using P2P to Connect to the HonView Touch App

You can use a QR code and the scan function in the Hon View Touch app on your SmartPhone
to add your DVR to your Honeywell devices in Hon View Touch. You can then access your DVR
through the WAN.
To add a DVR to the Hon View Touch app
Click P2P in the Network configuration interface to open the P2P configuration interface.
www.honeywell.com/security
Figure 3-24 Multicast Configuration Interface
Enter a multicast IP Address. This address must be valid for multicasting, and should be
in the range of 224.0.0.0 to 239.255.255.255 for IPv4 or have the prefix ff00::/8. An address
in the range 239.252.0.0 to 239.255.255.255 is recommended.
Enter a multicast port number in the Port field, or use the default setting (36666).
Click Save.