Powering The Hybrid Lt Dvr; Configuring The Hybrid Lt Dvr; Next Steps; Operating The Dvr Remotely - Honeywell Rapid Eye Hybrid LT Installation Manual

Hide thumbs Also See for Rapid Eye Hybrid LT:

Table of Contents

Introduction

Powering the Hybrid LT DVR

Honeywell recommends that you apply power to the Rapid Eye DVR through an

uninterruptible power supply (UPS). For more information, see

Caution

In Europe, a UPS is required to meet EN50130-4 Euro Norm.

Whether you plan to operate the DVR onsite (using LocalView) or remotely (using View

software through a network connection), you need to do basic DVR configuration with

LocalView.

Note

For remote operations using only a dial-up connection, you do not need to

configure the connection with LocalView.

The following chapters in this guide provide detailed procedures and reference materials,

starting with

Chapter 2,

Installation.

If you plan to perform a quick connection after the installation, to connect remotely to Rapid

Eye Hybrid LT DVRs, you should refer to the

Video Recorders System Administrator

LT Digital Video Recorders Common Operator

You can also consult the

Rapid Eye™ Hybrid HD and Hybrid LT Digital Video Recorders

Remote View Operator

Guide, which offers more procedures and reference material.

Powering Up

Rapid Eye™ Hybrid HD and Hybrid LT Digital

Guide, and the

Rapid Eye™ Hybrid HD and Hybrid

Guide, for the commonly used procedures.

on page 31.

Table of Contents