Configuring Network-Type Atm/Pos Settings - Honeywell HRHT4041 Remote User Manual

94 | Performance Series HQA Digital Video Recorder Remote User Guide

Configuring Network-type ATM/POS Settings

The ATM/POS protocol is required.
There are two Network types: with or without the protocol.
The Source IP is the host IP address that sends out the information (usually this is the IP of the
device host).
The Destination IP is the IP of other systems that receive the information.
With the Protocol
If you are setting up ATM/POS with the protocol, then all you need to do is set the following:
•
•
1.
2.
3.
4.
Without the Protocol
You usually do not need to set the Source Port and Destination Port.
There are a total of four IP groups. The recording channel applies to only one group (optional).
There are 6 ID groups. therefore 6 different types of information about the video can be verified.
www.honeywell.com/security
Source IP
Destination IP (you sometimes need to enter the corresponding port number)
Click to select the Network tab.
Figure 3-59 ATM/POS Configuration Interface - With Protocol
Select the ATM/POS protocol from the Protocol drop-down menu.
Enter a Source IP Address and a Destination IP Address.
Click Save.