Configuring The Mobile Settings - Honeywell HRHT4041 Remote User Manual

Figure 3-13 CDMA/GPRS Configuration Interface
Table 3-7 3G/4G Configurations
Configuration
WLAN Type
APN & Dial No.
AUTH
User Name
Password
Pulse Interval
Note If the Pulse Interval is 0, then the system does not end the 3G connection after you
close the extra stream monitor.
Note The Pulse Interval here is for the extra stream only. This field is inactive if you are
using a main stream monitor.
IP Address
Wireless Signal

Configuring the Mobile Settings

Click the Mobile Setup tab in the Network Configuration interface to open the Mobile Setup
configuration interface.
Description
Select a 3G network type to distinguish this 3G module from
different ISPs. Choose from WCDMA, CDMA1x, for example.
APN and the Dial No. are important PPPoE parameters. The
APN (Access Point Name) and the Dial No. are automatically
received by the DVR after connecting to a 3G module.
Authorization. Choose from PAP, CHAP, or NO_AUTH.
Enter a user name.
Enter a password.
Configure a time for ending the 3G connection after you close
the extra stream monitor. For example, if you select 60 here,
the DVR ends the 3G connection 60 seconds after you close
the extra stream monitor.
Enter the DVR's IP address that was searched for and
connected via the Wifi network.
Click to search for and find wireless signals.
Configuration | 47
800-22740 - A - 02-2017