Specifications - semaphore KINGFISHER PLUS+ Hardware Reference Manual

4.3.4 CP-12 Specifications
Flash Memory
Batter y Type
Batter y Life
(module unpowered)
Real-time Clock Accuracy
W atchdog timer
Status Indication
Communications Ports
Port 1 (RS-232)
Ports 2 and 3 (Optional)
Configuration Software
RTU Address Range
Communications Protocol
Default Data Format
Analogue Block Processing
PID Block Processing
Redundancy
Internal Power Consumption
(without Option Boards)
I/O Bus Data Rate
CM Bus Data Rate
Operating Temperature
Storage Temperature
Operating Humidity
*) When 2 processors are present on the backplane, one processor can be swapped while the RTU
is still running. However, a hot swap will cause a Warm Start of the remaining processor. All ports
will be re-initialized and ready for communications within 6 seconds. New data received during the
changeover may be lost. To preserve data and for more information please see the Redundancy
appendix in the Toolbox 32 manual.
Hardware Manual Version 7.16
PROCESSOR SPECIFICATIONS
40 MHz x86
Processor
16 bit data bus
W ord Size
Yes
BIOS
512 KB
512 KB
SRAM
Lithium Primary (not rechargeable)
7 years @ 25°C
1 minute per month (+/- 20 ppm)
Yes
Yes
1-3 (1 fixed, 2 option ports)
300 to 115200 Baud (factory default 9600 8-N-1)
For supported port types, please see the
chapter
Toolbox 32
1 – 249 (expandable to 2000 by using multiple masters)
Kingfisher, Modbus + many more
8 data bits, no parity, 1 stop (8, N, 1)
Yes
Yes
Yes. Two CP-12 modules can be installed in the one RTU.
One processor module must be installed in an odd numbered
slot and one in an even numbered slot.
150 mA from +5 V
250 kbps
83 kbps
-20 to +70 °C
-40 to +85 °C
5 to 95 % RH (non-condensing)
Yes*
Hot Swap
http://www.servelec-semaphore.com/
Kingfisher Plus+ Hardware Manual
Option Boards
bus on backplane
DC
Page 70