FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. There should be approximately 6 mm (0.25 in.)
free-play in the cable.
5. Tighten the jam nut to secure the adjustment;
then slide the rubber boot back into position.
Adjusting Engine RPM
To properly adjust the idle RPM, a tachometer is
necessary. To adjust idle RPM, use the following
procedure.
1. Set the brake lever locks. Start the engine and
warm it up to normal operating temperature.
! CAUTION
Make sure the engine is fully warm before adjusting
the idle RPM.
2. Turn the idle adjustment screw in or out until the
engine idles at 1700 RPM.
! WARNING
Adjust the idle to the correct RPM. Make sure the
engine is at normal operating temperature before
adjusting the idle RPM.
www.mymowerparts.com
Back
2-8
(Idle)
KM004A
Back to TOC
Transmission Lubricant
1. Park the ATV on level ground.
2. Remove the level/fill plug from the left-rear of
the transmission. Be careful not to allow con-
taminates to enter the opening.
3. Remove the drain plug from the bottom of the
transmission and drain the lubricant into a drain
pan.
4. Install the drain plug and tighten to specifica-
tions (see Section 10). Pour the recommended
lubricant in the fill/level hole. Install the
level/fill plug.
5. Start the engine (while the ATV is outside on
level ground) and drive it a short distance.
6. Turn the engine off and wait approximately one
minute. Remove the level/fill plug and recheck
the lubricant level. The level should be visible at
the level hole. If lubricant is not visible, add rec-
ommended lubricant until the level is visible at
the level hole.
7. Inspect the area around the drain plug for leaks.
Back to Section TOC
KM039A
KM038A
Next