JRC JCY-1800 Installation Manual page 78

4. Cabling
JCY-1800/1850 VDR/S-VDR Installation Guide
* If the Radar equipment is JMA-900M, the Radar Interface Unit (NWP-46) should be installed.
Connection cable (DVI-DSUB15) is an accessory of NWP-46.
* JMA-900M series Radar should be connected to the S-VDR
* JMA-9800 series Radar should be connected to the S-VDR
DOC No. 7ZPJD0387C
3) JMA-900M series (Chart Radar)
Resolution
Scan
Color
Output Signal
Connector
Vertical Refresh rate
Sync Impedance
Signal level
Polarity
Horizontal Frequency
Sync Impedance
Signal level
Polarity
Video Pixel frequency
signal Impedance
Signal level
Polarity
4) JMA-9800 series
Resolution
Scan
Color
Output Signal
Connector
Vertical Refresh rate
Sync Impedance
Signal level
Polarity
Horizontal Frequency
Sync Impedance
Signal level
Polarity
Video Pixel frequency
signal Impedance
Signal level
Polarity
*To make the output to the VDR viable, please incorporate an amplifier (NAD-30)
and VDR connection kit (MPBC36097) into the RADAR equipment, using a kit
provided by JRC.
1600 x 1200 pixel
Non-interlaced
Color
R / G / B / Vs / Hs
BNC
60 Hz
75 ohms
+5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Negative
75 kHz
75 ohms
+5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Positive
162.000 MHz
75 ohms
+0.7 - 0V
Positive
1024 x 768 pixel
Non-interlaced
Color
R / G / B / Vs / Hs
BNC
60 Hz
75 ohms
+5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Negative
48.36 kHz
75 ohms
+5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Negative
125.000 MHz
75 ohms
+0.7 - 0V
Positive
68