JRC JCY-1800 Installation Manual page 102

5. Instruction
JCY-1800/1850 VDR/S-VDR Installation Guide
Table 5-4: Names and Functions of the Data Processor Unit
No.
1) REC LED (MCB):
Lights up when the data are being successfully recorded into the Protective Capsule Unit.
2) REC START SWITCH (MCB):
Used to restart recording the data into the Protective Capsule Unit.
3) REC STOP SWITCH (MCB):
Used to stop recording the data into the Protective Capsule Unit.
4) CARD LED (MCB):
Lights up when the data are being successfully recorded into the CF CARD.
Turned off when the CF CARD is on operation.
5) MEDIA LED (MCB):
Blinks when a CF CARD is not loaded or does not record data correctly.
6) CARD STOP SWITCH (MCB):
Used to stop recording the data into the CF CARD.
7) CF CARD (MCB):
Used as an alternative record media onto which the same data as the one stored in the Protective Capsule
Unit are recorded.
8) CF CARD EJECT BUTTON (MCB):
Used to remove the CF CARD from the system. Confirm that CARD LED is off then press CARD STOP
SWITCH to eject the CF CARD.
9) AUDIO IN CONNECTOR (MCB):
Used as a connector through which audio signals that are received from the Microphone Unit and the VHF
radio equipment are input. It is connected to the Audio Junction Board of the external interface.
10) HUB (MCB):
The HUB Unit with four port switching functions.
One of the components of VDR-LAN.
11) LAN CONNECTOR (MCB):
Connected to the external HUB Unit.
12) RMS OP. LED (RMB):
Lights up when the Remote Maintenance Board is operating.
13) RMS SYS. LED (RMB):
Lights up when the Remote Maintenance Board is operating abnormally.
14) DATA LED (RMB):
Lights up when the Remote Maintenance Board can not receive any data.
15) HUB (RMB):
The HUB Unit with four switching function.
One of the components of JRC-LAN.
16) LAN CONNECTOR (RMB):
Connected to the external HUB Unit.
17) RGB1 IN CONNECTOR (FGB):
Used as a connector through which the image signals from the main RADAR are input. Connected to the
RGB connector panel.
18) RGB2 IN CONNECTOR (FGB):
Used as a connector through which the image signals from the sub RADAR are input. Connected to the
RGB connector panel.
19) LAN CONNECTOR (FGB):
Connected to the HUB Unit of the MCB.
DOC No. 7ZPJD0387C
Names and Functions
92