JRC JCY-1800 Installation Manual page 118

8. Troubleshooting
JCY-1800/1850 VDR/S-VDR Installation Guide
8.1.2. Symptom Table for The Data Processor Unit (NDL-46)
Symptom
REC LED fails to light.
CARD LED fails to light
up.
MEDIA LED blinks.
DOC No. 7ZPJD0387C
Causes
The Recording Control Unit is off.
The power is not supplied to the Protective
Capsule Unit.
The recording of data onto the Protective Capsule
Unit has been stopped manually.
Faulty wiring between the Recording Control
Unit and the Protective Capsule Unit
Fault in the Recording Control Unit
Fault in the Protective Capsule Unit
The CARD STOP SWITCH is left on.
No CF CARD is loaded.
Fault in the Recording Control Unit
Fault in the CF CARD
No CF CARD is loaded.
Fault in the Recording Control Unit
Check the switchboard.
Turn on the Power Supply Unit.
Press the REC START SWITCH on the Main
Control Board and restart the recording of
data.
Check the Connection Box.
Check the LAN communication by a PING
command.
MCB: PING 192.168.110.3
Capsule: PING 192.168.110.2
In case a no response
MCB (CDJ-2304) :
Fault in a circuit board or setting data
Capsule :
Fault in a circuit board or setting data
Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
Exchange a broken Unit (MCB or Capsule).
Press the CF CARD EJECT BUTTON and
remove it from the Main Control Board. Then
put it back again.
Insert a CF CARD into the CARD slot of the
Main Control Board.
Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
Press the CF CARD EJECT BUTTON and
remove it from the Main Control Board. Then
put it back again.
In not activating, format the CF card into
FAT32 with PC.
Insert a CF CARD into the CARD slot of the
Main Control Board.
Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
108
Actions to be taken