JRC JCY-1800 Installation Manual page 115

Table 7-1: ERROR code table of the Operation Panel Unit (3/3)
ALARM DETAIL
SYSYTEM CODE
7 0
7 1
7 2
7 3
7 4
7 5
7 6
8 0
CATEGORY
FGB CH1 Radar image data error
The FGB does not receive RGB signals from Radar connected to CH1.
CH2 Radar image data error
The FGB does not receive RGB signals from Radar
FGB Communication error
The MCB does not communicate with the FGB normally via LAN.
FGB Setup data reception error
The MCB does not receive the setup data of FGB successfully.
FGB Control error
The MCB did not communicate with FGB successfully.
FAN alarm of NWP-46
FAN built in NWP-46 (Radar Interface Unit) is out of order.
FGB Real time monitor data transmission error
The IP address for transmitting image data is not registered in the FGB yet.
RMB RMB communication error
The MCB do not communicate to the RMB normally via LAN.
RMB Control error
The MCB is unsuccessful in control of the RMB.
JCY-1800/1850 VDR/S-VDR Installation Guide
CONTENTS
105
7. Error Display
connected to CH2.
DOC No. 7ZPJD0387C