JRC JCY-1800 Installation Manual page 30

1. Specifications
JCY-1800/1850 VDR/S-VDR Installation Guide
c) Continuous AUTO mode
When the switching SW is not connected and two radars are connected, images will be recorded
continuously by AUTO mode.
1.10.4. Operation Panel Unit: OPU (NCG-169)
(1) Function:
(2) Performance:
a) Type:
b) Power supply:
c) Indication:
d) Operation:
(3) NSK operation:
a) Operation
b) Indication
(4) Environmental condition:
a) Operating temperature:
b) Temperature and humidity:
c) Vibration:
(5) General specification:
a) Size:
b) Mass:
c) Color:
DOC No. 7ZPJD0387C
CH1 recording mode: Images of CH1 are forced to be recorded.
If no images are inputted to CH1, the image data will not be recorded.
CH2 recording mode: Images of CH2 are forced to be recorded.
If no images are inputted to CH2, the image data will not be recorded.
PI_1（TB406）
OPEN
OPEN
CLOSE
When in operation by AUTO mode, the objective radar images will be recorded if the power of
nonoperational radar is turned off. If the nonoperational radar is set standby, outputting radar
images is not stopped and therefore, only the X-band radar screen without any echoes will be
recorded.
Visible indication and audible alarm for VDR system alarm in the Wheelhouse
Display of the cause of an error
Input of Heading initial value
Flush mount type or Wall mount type
Supplied from the Recording Control Unit NDV-1800/1850
LED lighting for alarm indication
4 digit LED for error code indication
Buzzer (mutable by ACK switch)
Alarm acknowledgement
Dimmer of LED
(When the NSK interface board is added.)
Entry of the initial value of heading
Heading value indication
-15°C to +55°C (IEC 60945 protected type)
+40°C, 93%
2Hz to 13.2Hz ±1.0mm
13.2Hz to 100Hz 0.7G
145(w) x 50(d) x 165(h) mm
0.3kg
N4 semi-gloss texture
PI_ 2（TB406）
OPEN
CLOSE
OPEN
20
RADAR Recording Mode
AUTO
CH1 record
CH2 record