BIO RAD PTC-200 Operation Manual page 62

Enter the numerical value of the increase or decrease in hold time (1.0 is used in the
example below):
Press «Proceed». The Ext value just entered will move to the third line of the screen, and
a confirmation menu will be displayed on the last line:
Select one of the displayed choices, then press «Proceed»:
• Yes accepts the Ext value and displays the Enter Menu again. Use the Enter
Menu to enter the next step in the program.
• No allows reentry of the Ext value.
• Option displays the Options Menu again. Use the Options Menu to enter
another option for the step.
Entering a Beep Option
To enter a beep, select Beep from the Options Menu for a temperature step or a ramp
step, then press «Proceed». The word "Beep" will be displayed on the third line of the
screen, and a confirmation menu will be displayed on the last line:
Select one of the displayed choices, then press «Proceed»:
• Yes accepts the Beep option and displays the Enter Menu again. Use the
Enter Menu to enter the next step in the program.
• No cancels the Beep option.
• Option displays the Options Menu again, if a temperature step is being modified.
Use the Options Menu to enter another option for the step. (Option will not be
displayed if a ramp step is being modified, since Beep is the only option available
for ramp steps.)
Tech Support: 1-800-4BIORAD • 1-800-424-6723 • www.bio-rad.com
Enter: CUSTO M 1
1= 92.0 f o r 0 : 3 0
+
Sec / c y c l e : + 1
Enter: CUSTO M 1
1= 92.0 f o r 0 : 3 0
+ 1 sec / cycle
OK? _YES No Option
Enter: CUSTO M 1
1= 92.0 f o r 0 : 3 0
Beep
OK? _YES No Option
Creating Programs
6-17