Lattice Semiconductor XP2 Advanced User Manual page 28

Lattice Semiconductor
Figure 10. Device Information Dialog
12. Check that the LSC ispVM System window appears as it does in Figure 11.
Figure 11. ispVM System Interface
13. To begin the download of the bitstream into the SPI Flash, press the GO menu button. You will see a small
counter display window start up and then that window will change to a Processing address window. A blue
section of that processing window will start to fill in from the left side until it reaches the right side of the win-
dow. When downloading to SPI Flash is complete, ispVM will then begin to verify the downloaded bitstream
loaded into the SPI Flash with another small processing window and blue bar moving across it.
14. Upon successful verification of the downloaded bitstream to SPI Flash, the LatticeXP2 device can then be pro-
grammed by powering down the evaluation board and re-applying power.
15. You should now see the LatticeXP2 evaluation board's LED digit display incrementing from 0 to 9 and a to f, the
digit decimal point should be blinking, and the LEDs to the left of the digit should show the internal counter
state while the digit count is incrementing.
Evaluation Board User's Guide
28
LatticeXP2 Advanced