Search Commands - Honeywell N3680 User Manual

F7
F2
06
0D
The data is output as:
123456
<CR>
EA—Move the cursor to the end
Move the cursor to the last character in the input message. Syntax = EA.

Search Commands

F8—Search forward for a character
Search the input message forward for "xx" character from the current cursor posi-
tion, leaving the cursor pointing to the "xx" character. Syntax = F8xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
Example: Send bar code data that starts after a particular character
Search for the letter "D" in bar codes and send all the data that follows, including
the "D." Using the bar code above:
Command string: F844F10D
F8
44
F1
0D
The data is output as:
DEFGHIJ
<CR>
68
"Move the cursor to the beginning" command
"Send a number of characters" command
Number of characters to send
Hex value for a CR
ASCII Conversion Chart (Code Page 1252),
"Search forward for a character" command
Hex value for "D"
"Send all characters" command
Hex value for a CR
beginning on page 174 for
N3680 Decoded Engine User Guide