Adtec RD-71 User Manual page 23

IP Rx Menu
Item Function
Multicast Rx IP Multicast IPA sets the multicast receive
Group IP address. IP Multicast receiving is
supported from compatible streamers. The
range of the multicast group IP is
224.XXX.XXX.XXX to 239.XXX.XXX.XXX -
XXX represents any number 0 through 255.
This can be either regular class A, B, C IP
address or a multicast IP address.
Multicast Rx Port number are used for receiving UDP/RTP
Port transfers in conjunction with Multicast IPA.
The valid range is 0-65535. If the port
number is set to 0, then no UDP transfers
will take place. 2000 is default.
Source Specific Configures the multicast receive Source
Multicast Specific IP Address. This configuration
Address should be configured to 0.0.0.0 (any source
multicast) in most IGMPv2 multicast
applications. This configuration is an
advanced configuration used for
redundancy, security, or IGMPv3 multicast
applications. It does not function for unicast
reception.
Multicast The multicast connector configuration
Connector determines the physical port of where the IP
stream will be received, IP 1 or IP 2 ports.
Latency Multicast Latency sets the latency delay
before the decoder begins playback from
the multicast source and should be argued
as a millisecond value.
If the MULTICASTLATENCY delay time is too
large, and the internal delay buffer is about
to overflow, the system will start the
multicast playback early to prevent the
overflow. A log message is generated when
this condition occurs.
Multicast Sets the timeout value for return to normal
Timeout video playback after video multicast packets
are no longer detected. The default timeout
value is 300 milliseconds. If the timeout
value is set too low, the multicast receive
may timeout during normal reception if the
Options
0.0.0.0 -
255.255.255.255
0 - 65535
0.0.0.0 -
255.255.255.255
IP1
IP2
4ms min. - max (rate
dependent)
500ms (default)
33 - 30000ms
300ms (default)
23