Adtec RD-71 User Manual page 29

DolbyD Configures the audio engine to
Mode Pass-through ( COMPRESSED )
or decode ( 2/0 STEREO ) if a
Dolby Digital AC3 PID is
detected for the selected
Audio input. Mpeg1Layer2
always decodes, and LPCM /
Dolby E always Pass-through,
regardless of this setting.
Dolby Decode requires feature
key capability.
DolbyE Line This is used to configure Dolby
E placement in the SDI output
and is configurable per audio
engine. When set to AUTO
(-1), the default configuration,
the Dolby E line is placed
within the valid line number
range for the video resolution.
The Dolby E line may be
manually configured to a value
within range. Valid ranges for
Dolby E line placement are
resolution and frame rate
dependent. If the configured
value is not valid, the system
will use the valid line used by
the 'AUTO' mode. The Dolby E
line status information can be
used to see the actual Dolby E
line placement.
View Dolby E line ​
more information.
Analog Vol. Adjusts the analog volume of
Pair 1 & 2 the first pair in dB increments
SDI Audio
Matrix 1-8
SDI Audio The SDI audio matrix allows
Matrix the user to route, duplicate, or
disable audio pairs within the
SDI embedded output.
PASSTHRU (default)
DECODE - STEREO
-1 - 4096
-1 = AUTO
t able​ for
-49 - +18 dBu
DISABLE, Disable audio output on
selected SDI pair
AUTO, default, Invokes automatic SDI
pair assignment. This is the default
setting.
AUDIO1, Route Audio 1 to the selected
SDI pair
AUDIO2, Route Audio 2 to the selected
29