Table of Contents
Advertisement
The SVC-FILTR key must be enabled to configure Service Filtering. When filtering is
enabled, a maximum of 5 programs are allowed on any given output. If filtering is disabled,
all programs available on the selected input for decode are available on the output, ie. unit
is in service pass through mode and no longer routing.
Configure Service Filter on ASI
To configure service filtering on the ASI output, visit the TS Output -> ASI Tx tab. First
choose the ASI Output Source. The ASI Output can be sourced from ASI IN, RF1 IN or RF2
IN, depending on demodulator hardware option.
Then, choose the ASI Output behavior or ASI Output TMR. ASI Output TMR determines the
ASI egress rate. When set to AUTO, the default, the output rate will be the sum of all filter
PIDs configured for the output + minimal NULL stuffing. When set to NATIVE, the output
TMR is set to match the INPUT source TMR. MANUAL is a user defined rate.
Then, choose the service required to filter from the Available Service list. Clicking the right
arrow will add the service to the Assigned Service list.
When the ASI Filter is set to ENABLED and Apply is clicked, you shall now see the selected
service on the ASI Output.
94
Hide quick links:
Advertisement
Table of Contents
