Adtec RD-71 User Manual page 44

Web UI - Input
RD Services​ allows input and program selection for the decoder. The IRD can be
configured for 'Select First Found' next to the given input (ASI, RF1, RF2, IP), a specific
program if programs are detected or an 'Advanced Input' selection can be made if no
services have been connected to the IRD yet.
Select First Found​ sorts the programs in numerical order and decodes the first 'decodable'
service. If a service is encrypted and the service fails to decrypt (wrong BISS key, BISS
configuration OFF or non-BISS encryption state), the next service will be attempted to be
decoded. The IRD will continue attempting services until a decodable service is found. If
the input fails or if a new input is detected, the first found mechanism will start over again.
Outputting video is the #1 priority when in Select First Found mode. Click the radio button
next to the desired input to 'Select First Found'.
The​ Reset​ input button can be used to clear inputs and restart the decode session. In rare
cases, this may be needed if the decoder does not recover properly. The reset button will
reset the decode session in a few seconds as opposed to waiting for an entire system
reboot.
Manual Selection​ occurs when the 'SELECT' button is pressed next to a listed service. The
decoder will ONLY decode the Service ID on the provided input where the SELECT button
was pressed. This is "live" manual selection. Only services that are "live" are displayed in
the tables. If the Service ID fails or is removed, the decoder will stop and fall to the fault
mode state as configured on the Video Output tab. The decoder will resume once the
Service ID is returned to a valid state.
Advanced Input​ is available for operators who want to pre-configure the Input and Service
ID when the Service ID does not exist. The advanced input is available for "non-live"
services. When Service Number "-1" is entered, the unit will be in "Select First Found"
mode.
44