Overall Flowchart Of The Installation Process; Installing The Mechanical Accessories Into The Cabinet - ABB ACS880-04 Hardware Manual

Overall flowchart of the installation process

Step Task
1 Install the Rittal parts and drive module
mechanical accessories into the cabinet.
3 Connect the power cables to the cabling panels.
4 Install the drive module into the cabinet.
5 Install the external control unit.
6 Connect the control cables.
7 Install the remaining parts, for example, cabinet
doors, side plates, etc.

Installing the mechanical accessories into the cabinet

Install the mechanical accessories into the cabinet as shown in appendix
drawings for installing full cabling panels (option +H381) in a Rittal TS 8 400 mm wide
cabinet on page 247.
If you do not use Rittal support rails on the bottom of the cabinet but make an own bottom
plate instead, see the dimension drawing on page
the thickness of the bottom plate is not 2.5 mm (0.1 in.), adjust the dimensions accordingly.
Installation example with full cabling panels (option +H381) 131
For instructions, see
Installing the mechanical accessories into the
cabinet
step drawings for installing full cabling panels
(option +H381) in a Rittal TS 8 400 mm wide
cabinet
Connecting the power cables,
Installing the drive module into the cabinet,
page
Mounting the external control unit,
Connecting the control cables to the terminals
of the control unit,
The component manufacturer's instructions
213
on page 131 and appendix
on page 247
page
135
page 107
Step-by-step
for the correct dimensions. Note: If
Step-by-
132.
page 105