Csa Marking; China Rohs Marking; Eac (Eurasian Conformity) Marking; Approvals - ABB ACS880-04 Hardware Manual

•
The cables located within the motor circuit must be rated for at least 75 °C (167 °F) in
UL-compliant installations.
•
Integral solid state short circuit protection does not provide branch circuit protection.
The input cable must be protected with fuses. Suitable IEC fuses are listed on page
and UL classified fuses on page 182. These fuses provide branch circuit protection in
accordance with the National Electrical Code (NEC) and Canadian Electrical Code. For
installation in the United States, also obey any other applicable local codes. For
installation in Canada, also obey any applicable provincial codes.
Note: Circuit breakers must not be used without fuses in the USA. See page
suitable circuit breakers.
•
The drive provides motor overload protection. For the adjustments, see the firmware
manual.
•
For drive overvoltage category, see page 190. For pollution degree, see page 190.

CSA marking

The drive modules are CSA marked.

China RoHS marking

The People's Republic of China Electronic Industry Standard (SJ/T 11364-2014) specifies
the marking requirements for hazardous substances in electronic and electrical products.
The green mark is attached to the drive to verify that it does not contain toxic and
hazardous substances or elements above the maximum concentration values, and that it
is an environmentally-friendly product which can be recycled and reused.
RCM marking
RCM marking is required in Australia and New Zealand. An RCM mark is attached to the
drive modules to verify compliance with the relevant standard (IEC 61800-3:2004),
mandated by the Trans-Tasman Electromagnetic Compatibility Scheme.
For fulfilling the requirements of the standard, see section
3:2004 on page 195
WEEE marking
The drive is marked with the wheelie bin symbol. It indicates that at the end of life the drive
should enter the recycling system at an appropriate collection point and not placed in the
normal waste stream. See section Disposal on page 191.

EAC (Eurasian Conformity) marking

The drive has EAC certification. EAC marking is required in Russia, Belarus and
Kazakhstan.

Approvals

The drive is marine type approved. For more information, see ACS880-01/04 +C132
marine type-approved drives supplement (3AXD50000010521 [English]).
.
Technical data 197
Compliance with EN 61800-
181
75 for