Installing I/O Extension, Fieldbus Adapter And Pulse Encoder Interface Modules; Wiring The Optional Modules - ABB ACS880-04 Hardware Manual

120 Installation instructions
Installing I/O extension, fieldbus adapter and pulse encoder

interface modules
See page 38 for the available slots for each module.
WARNING! Obey the safety instructions in chapter
ignore them, injury or death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section
18 before you start work.
2. Insert the module carefully into its position on the control unit.
3. Tighten the grounding screw torque of 0.8 N·m. Note: The screw tightens the
connections and grounds the module. It is essential for fulfilling the EMC requirements
and for proper operation of the module.

Wiring the optional modules

See the appropriate optional module manual for specific installation and wiring
instructions.
Precautions before electrical work
3
Safety instructions. If you
on page