Install the metallic shroud with ground bar as shown below.
Combi screw M4×8
Torx T20 2 N·m
Drive module with full cabling panels (option +H381)
For an installation example of the drive module with full cabling panels (option +H381) into
a Rittal cabinet including power cable connection procedure, see chapter
example with full cabling panels (option
Note: This installation alternative is not possible without pedestal (with option +0H354).
Drive module without full-size output cable connection terminals
(option +0H371) and IP20 shrouds (option +0B051)
The power cables can be connected directly to the drive module input and output terminals
with cable lugs or by busbars. The drive module can also be installed self standing on the
floor in an electrical equipment room when the power cable terminals and electrical parts
are protected against contact and the drive module is grounded properly.
Drive module configuration with power cable connection terminals
on the right-hand side of the drive module (option +H391)
For an installation example of the drive module with option +H391 into a Rittal cabinet, see
chapter
Step-by-step drawings for option +H391 installation example in Rittal TS 8 600
mm wide cabinet
on page 251. Otherwise, install the drive module as the standard drive
module configuration.
+H381), page 129.
Installation instructions 95
Installation