ABB ACS880-04 Hardware Manual page 248

248 Step-by-step drawings for installing full cabling panels (option +H381) in a Rittal TS 8 400 mm wide cabinet
ABB parts
7 Output cabling panel
8 Side guide (2 pcs)
11 Input cabling panel
12 Telescopic extraction and
insertion ramp
7
Tapping screw M6×12 Torx T30 (Hex) (4 pcs)
7. Install the output cabling panel. Note: After you have installed the output cabling panel,
you can remove the support rail that lies under the panel if there is not enough space
for cables.
8. Install the side guides to the output cabling panel (2 screws for each side guide).
9. Attach the grounding busbar to the input cabling panel. Back view is shown below.
10. Install the side guides to the input cabling panel (2 screws for each side guide).
11. Attach the input cabling panel to the punched section.
12. Install the Telescopic extraction and insertion ramp
10
10
8
8
8
8
Combi screw M4×8 Torx
T20 (4 pcs)
8
8
This support rail is used for setting the correct
position of the cabling panels. You can remove it
after the installation.
11
10
10
Tapping screw
M6×12 Torx T30
(Hex) (4 pcs)
Combi screw M4×8 Torx
T20 (4 pcs)
Combi screw M8×30 Torx
(2 pcs)
12
9
9
M8×16
M8×16
Hex
Hex
R10 R11