Table 7-2 Totalizer Controls (The "N" In <Fn> = Channel Number) - Siemens SITRANS FUP1010 Operating Instructions Manual

4. Scroll down to the [Totalizer Mode] menu and press the <Right Arrow> to select the Totalizer
5. Press the <Up/Down Arrows> to select the desired mode.
6. Press <ENT> to store selection.
Totalizer Mode Controls
Table 7-2 Totalizer Controls (the "n" in <Fn> = channel number)*
F1 CLEAR
F2 (also clears
overflow)
F3
F4
F1 NOTOT
F2 (Totalizer Freeze)
F3
F4
F1 LAPTOT
F2 (Totalizer snapshot)
F3
F4
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
Mode option list.
Resetting the Totalizer registers clears all total data accumulated during operation.
Note: In Dual Path mode, the Totalizer operates only on the virtual system channel
(Ch 3). Therefore in this case, the CLEAR trigger would be <F3> <1>.
Invoking the NOTOT command disables the Totalizer. Totalization will not resume
until you repeat the <Fn> <2> key sequence. When you activate NOTOT, an N
precedes the TOTAL symbol (i.e. [NTOTAL]) on the LCD Screen.
The LAPTOT command freezes the Totalizer screen display. However, the
flowmeter will continue to update its internal registers. The flowmeter will show the
current total when you repeat the <F1>< 3> key sequence. When you activate
LAPTOT, an L precedes the TOTAL symbol (i.e., [LTOTAL]) on the LCD screen.
Functions
7.1 Selecting Flow Units
75