Siemens SITRANS FUP1010 Operating Instructions Manual page 40

Connecting
5.2 Sensor Wiring
①
②
③
④
Figure 5-8
Installation Procedure
1. After receiving the Number Index from the Installation Menu, prepare the pipe surface area
2. Degrease the surface and remove any grit, corrosion, rust, loose paint, etc.
3. Assemble the sensors to the spacer bar, with the cable connectors facing away from each
38
Sensor cable connection
1011HPS Series Sensor
Spring Clip
Spacer Bar
Reflect Mount with EZ-Clamp and Spacer Bar
where the sensors will be mounted. Check to ensure that you have a matched set of
sensors. They both should have the same S/N number but marked with either an "A" or "B"
(e.g., 100A and 100B).
other as shown above. The spacer bar is attached to a sensor using a sensor index screw.
⑤
Customer's Pipe
⑥
Sensor Index Screw
⑦
Sensor Index Screws-Storage Location
⑧
1011PPS Series Sensor
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01