Siemens SITRANS FUP1010 Operating Instructions Manual page 141

4. This selects the [Connection Description] dialog box. Enter a name for your connection
5. This selects the [Phone Number] dialog box. Move the cursor to the arrow at the right of
6. You will now see a blank terminal screen. Next left-click [File] on the top menu bar. Drag
7. Left-click the [Settings] tab. Expand the [Emulation] box by left-clicking the <Down Arrow>
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
(e.g., 1010N). You can optionally select an icon for this connection by clicking on one of
the icons displayed in the scrolling frame at the bottom of the window. Click [OK].
the [Connect Using] field. Left click on the arrow to expand the field and then move the
highlight down to [Direct to Com 1 (or 2)] depending on the port connected to the interface
cable. Click [OK] to select the [Com 1 (or 2) Properties] Dialog box. Set up your RS-232
parameters as shown in the example below. Left-click on the [OK] button.
the highlight down to [Properties] and then left-click.
on the right-hand side. Drag the highlight down to [VT-100] and then left-click to select it
(as shown below).
Appendix
A.4 Site Setup For SITRANS F
139