Siemens SITRANS FUP1010 Operating Instructions Manual page 145

Logger
Invokes the download of all data stored in the Datalogger. Note that the Datalogger data is not
erased from the flowmeter memory when it is downloaded. It is recommended to capture this
information into a file with a "csv" extension, which can be easily imported into MS EXCEL.
SITE
Invokes a full site download for a single channel or multi-path 1010 flowmeter.
SITE "n"
Invokes a site download for channel "n", where "n" = the Channel # (1, 2, 3, 4, etc.).
DP "n"
Commands the flowmeter to download the digitized receive signal data for Channel or Path
"n".
CLRTOT
Clears the Totalizer for a single channel or multi-path 1010 flowmeter.
CLRTOT "n"
Clears the Totalizer for Channel "n" of a multi-channel flowmeter.
Lf on
Turns on the Line Feed at the end of any text string sent by the flowmeter.
Lf off
Turns off the Line Feed at the end of any text string sent by the flowmeter.
?
Provides a list of available Terminal Mode flowmeter commands.
Transferring information from a 1010 Flowmeter to the PC
With HyperTerminal active:
1. Point to [Transfers] and click.
2. Select [Capture Text].
3. Select desired drive path or directory, enter a file name, and click the Start button.
4. Use the following conventions for data file names:
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
Appendix
A.4 Site Setup For SITRANS F
143