Table 7- 6 Totalizer Controls (The "N" In <Fn> = Channel Number) - Siemens FUG1010 IP65 NEMA 4X Operating Instructions Manual

Functions
7.3 Selecting Flow Units
8. At the Terminal screen, press <ENTER> and the Data Display mode appears.
9. If not, to enter the Data Display mode type MENU and then press <Ctrl L>.
Table 7- 6 Totalizer Controls (the "n" in <Fn> = channel number)*
Key PC # Command
F1 CLRTOT
F2 (also clears
overflow)
F3
F4
F1 NOTOT
F2 (Totalizer Freeze)
F3
F4
F1 LAPTOT
F2 (Totalizer
snapshot)
F3
F4
F1 CLEAR
F2 (Batch/Tot
register)
F3
F4
F1 CLEAR
F2 (Makeup Latch)
F3
F4
*Use the <F1> key as the "Lead-in command" for 4-Path Totalizer operations.
106
Resetting the Totalizer registers clears all total data accumulated during operation.
Note: In Dual Path mode, the Totalizer operates only on the virtual system channel
(Ch 3). Therefore in this case, the CLRTOT trigger would be <F3> <1>.
Commands that can be invoked from Si-Ware or HyperTerminal:
Terminal Command: CLRTOT 1.
Invoking the NOTOT command disables the Totalizer. Totalization will not resume
until you repeat the <Fn> <2> key sequence. When you activate NOTOT, an N
precedes the TOTAL symbol (i.e. [NTOTAL]) on the LCD Screen.
Commands that can be invoked from Si-Ware or HyperTerminal:
Terminal Command: NOTOT 1 = Stop Totalizer
Terminal Command: NOTOT 1 = Start Totalizer
The LAPTOT command freezes the Totalizer screen display. However, the flow
meter will continue to update its internal registers. The flow meter will show the
current total when you repeat the <F1>< 3> key sequence. When you activate
LAPTOT, an L precedes the TOTAL symbol (i.e., [LTOTAL]) on the HyperTerminal
screen.
Clears the Batch/Sample Totalizer register. The flow meter maintains a separate
Totalizer register for Batching or Sampling applications but cannot be accessed
directly. It is used for relay control only. If you assign the system relay to this
function, a momentary (200 mS) relay pulse occurs whenever the BATCHTOT
register accumulates a specified liquid quantity. In the [Batch/Sample Tot] menu cell
the required total flow volume is entered to activate the relay,. This numeric entry
must reflect the selected flow total units. The [Totalizer Scale] menu cell shows the
applicable flow total units. The sign of the Batch/Sample Total determines positive or
negative accumulation.
Clears the Makeup Latch. Refer to the Span Data menu [Set Alarm Levels] and then
the [Makeup Latch] On / Off option.
Description
Operating Instructions, 01/2013, A5E02951519-AC
FUG1010 IP65 NEMA 4X