Totalizer Controls - Siemens SITRANS F Instruction Manual

Section 2
TOTALIZER CONTROLS (the 'n' in <Fn> = channel number)*
CLEAR
F1
(also clears overflow)
F2
1
F3
F4
NOTOT
F1
(Totalizer Freeze)
F2
2
F3
F4
LAPTOT
F1
(Totalizer snapshot)
F2
3
F3
F4
CLEAR
F1
(Batch/Tot Register)
F2
4
F3
F4
CLEAR
F1
(Makeup Latch)
F2
6
F3
F4
*Use the <F1> key as the "Lead-in command" for 4-Path Totalizer operations.
Resetting the Totalizer registers clears all total data ac-
cumulated during operation.
NOTE: In Dual-Beam mode, the Totalizer operates only on
the virtual system channel (Ch 3). Therefore in this case,
the CLEAR trigger would be <F3> <1>.
Invoking the NOTOT command disables the Totalizer. To-
talization will not resume until you repeat the Fn and Nu-
meric 2 key sequence. When you activate NOTOT, an N
precedes the TOTAL symbol (i.e., [NTOTAL]) on the LCD
Screen.
The LAPTOT command freezes the Totalizer screen
display. However, the flow computer will continue to up-
date its internal registers. The flow computer will show the
current total when you repeat the F1-Numeric 3 key se-
quence. When you activate LAPTOT, an L precedes the
TOTAL symbol (i.e., [LTOTAL]) on the LCD Screen.
Clears the Batch Sample totalizer register. See Batch/
Sample Tot.
Clears the Makeup Latch. See paragraph 2.7 The Data
Span/Set/CAL Menu and subparagraph 2.7.1 Span Data.
2-35
1010ENFM-3B