Siemens SITRANS FUP1010 Operating Instructions Manual page 144

Appendix
A.4 Site Setup For SITRANS F
Navigating through the Installation Menu
After accessing the Installation Menu, you can begin to setup your flowmeter according to the
instructions in this manual. The chart below shows the PC keyboard equivalents to the keypad
keys while you are in the menu.
SITRANS F 1010 Keyboard
<Up Arrow>
<Down Arrow>
<Right Arrow>
<Left Arrow>
<Menu>
<Datalog>
<CLR>
<ALT+Up Arrow>
<+/-> (chg sign)
<ENT>
Digits
/
X
+
-
=
.
Terminal Mode Menu Commands
In addition to Menu, the following commands (followed by the <ENT> key) can be used to
control the flowmeter while in Terminal Mode.
Note
The "n" refers to the flowmeter Channel number. For a dual channel Arithmetic site (Ch1 +
Ch2 or Ch1 – Ch2) the virtual Channel is number 3.
142
PC Keyboard
<Up Arrow>
<Down Arrow>
<Right Arrow>
<Left Arrow>
^L (Cntrl L)
^D (Cntrl D)
<Backspace> or <DEL>
^U (Ctrl U)
| (bar, shift + backslash)
<Carriage Return>
Digits
/
* (shift + upper case 8)
+
-
=
.
Description
Move up 1 menu cell (or Flow Display
screen)
Move down 1 menu cell (or Flow Display
screen)
Move right 1 menu cell (or Flow Display
screen)
Move left 1 menu cell (or Flow Display
screen)
Toggle between Menu and Flow Display
Generate Datalogger report
Deselect list selection
Logger Display Page Advance
Change numeric sign. Can also type (-)
key
Enter Key
Numerals 0 through 9
Divide by
Multiply by
Plus
Minus
Equals
Decimal Point
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01