Getting Started; Understanding The Display - Emerson Unidrive M400 User Manual

Safety Product Mechanical
information information installation
5

Getting started

This chapter introduces the user interfaces, menu structure and security
levels of the drive.
5.1

Understanding the display

The keypad can only be mounted on the drive.
5.1.1 Keypad
The CI-Keypad display consists of up to four rows of text. The upper two
rows show the drive status or the menu and parameter number currently
being viewed. When in status mode, an area one character wide and
four lines high on the right-hand side of the display, is reserved for
displaying actions that are active on the drive. The possible active
actions are given in Table 5-1.
When the drive is powered up, the lower two rows will show the status
mode parameters defined by Status Mode Parameter 1 (11.018) and
Status Mode Parameter 2 (11.019).
Figure 5-1 Keypad detail
1
2
Table 5-1 Key to Figure 5-1
1 Escape button
2 Start button
3 Navigation buttons (x4)
NOTE
The red stop button is also used to reset the drive.
The parameter value is correctly displayed on the keypad display as
shown in Table 5-2 below.
Table 5-2 Keypad display formats
Display formats
IP Address
MAC Address
Time
Date
Version number
Character
32 bit number with decimal point
16 bit binary number
Unidrive M400 User Guide
Issue Number: 2
Electrical Getting Basic Running
installation started parameters the motor
6
5
4
3
4 Stop/Reset button (red)
5 Status LED
6 Enter button
Value
127. 0. 0. 0
01ABCDEF2345
12:34:56
31-12-13 or 12-31-13
01.02.00.00
ABCD
21474836.47
0100001011100101
NV Media Card Onboard
Optimization
Operation PLC
Table 5-3 Active action icon
Active action icon
Alarm active
NV media card being accessed
Drive security active
User security unlocked
Motor map 2 active
User program running
Keypad reference active
Advanced
Technical data Diagnostics
parameters
Description
UL listing
information
59