Single Circuit Breaker With Double Busbar, Internal Voltage Selection - ABB REC650 Applications Manual

Section 10
Control
10.1.3.3
10.1.4
192

Single circuit breaker with double busbar, internal voltage selection

Bus 1
Bus 2
Fuse
Fuse
VT
VT
189
289
BKR1
52
Line
ANSI10000196 V2 EN
Figure 75: Connection of the SESRSYN (25) function block in a single breaker,
double busbar arrangement with internal voltage selection.
When internal voltage selection is needed, the voltage transformer circuit connections are
made according to figure 75. The voltage from busbar1 VT is connected to V3PB1 and the
voltage from busbar2 VT is connected to V3PB2. The voltage from the line VT is
connected to V3PL1. The positions of the disconnectors and VT fuses shall be connected
as shown in figure 75. The voltage selection parameter CBConfig is set to Double bus.
Setting guidelines
The setting parameters for the Synchronizing, synchronism check and energizing check
function SESRSYN (25) are set via the local HMI (LHMI) or PCM600.
This setting guidelines describes the settings of the SESRSYN (25) function via the
LHMI.
Common base IED value for primary voltage (VBase) is set in a Global base value
function, GBASVAL, found under Main menu/Configuration/Power system/Global
base values/X:GBASVAL/VBase. GBASVAL has six instances which can be set
independently of each other. The SESRSYN (25) function has one setting for the bus
reference voltage (GblBaseSelBus) and one setting for the line reference voltage
SMAI
VBus1
SMAI
VBus2
SMAI
VLine
Fuse
VT
1MRK 511 286-UUS A
SESRSYN (25)
V3PB1* SYNOK
V3PB2* AUTOSYOK
V3PL1* AUTOENOK
GRP_OFF V3PL2* MANSYOK
BLOCK MANENOK
BLKSYNCH TSTSYNOK
BLKSC TSTAUTSY
BLKENERG TSTMANSY
BUS1_OP TSTENOK
BUS1_CL VSELFAIL
BUS2_OP B1SEL
BUS2_CL B2SEL
LINE1_OP L1SEL
LINE1_CL L2SEL
LINE2_OP SYNPROGR
LINE2_CL SYNFAIL
VB1OK FRDIFSYN
VB1FF FRDERIVA
VB2OK VOKSC
VB2FF VDIFFSC
VL1OK FRDIFFA
VL1FF PHDIFFA
VL2OK FRDIFFM
VL2FF PHDIFFM
STARTSYN INADVCLS
TSTSYNCH VDIFFME
TSTSC FRDIFFME
TSTENERG PHDIFFME
AENMODE Vbus
MENMODE VLine
MODEAEN
MODEMEN
ANSI10000196-2-en.vsd
Application manual